![]() What kind of noise? Hiss, rumble, pops and clicks, and how is it measured? Also, are you concerned about the noise floor when the record is newly pressed, or after it has been played, and quite possibly damaged. Furthermore, the location on the record (the inner grooves have issues) and for bass, whether the signal is mono (equal in both left and right channels, or only present in one channel. This decreases the perceived noise, but significantly decreases the loudest recordible high frequency audio. In the case of vinyl, the upper limit can vary widely, and is controlled in the cutting lathe depending on the spacing between the grooves (which may have been varied within the recording), the frequency being recording, as a recording equalization curve (think RIAA EQ) is used which especially boosts the loudness of the high frequencies during the mastering of the record, and decreases the loudness in your turntable preamp. But all of that is way beyond the scope of this post.Īnalog audio is more complicated. It is actually more complicated because of the probable application of dither, the possibility of source identification by adding "inaudible" digital patterns to the source audio, the possible application of HDCD processing, etc. In theory, that sets the noise floor for a 16 bit recording at -96 dB. CDs have 16 bits, common audio files may have 16, 24 or more bits per sample. The lower limit is determined by the number of bits in the sample, each additional bit adds 6 dB. Think of it as a binary word with all "1"'s. The upper limit is defined as 0 dBFS (FS stands for Full Scale). For digital media, this is dependent on the number of bits used to quantize the waveform. To begin with, the dynamic range capability of media is the difference between the loudest sound that the media can store and the "noise floor" of the media. And your source material, transfers from vinyl, probably deserve different treatment than bit-accurate rips of (digital) CD's. ![]() I'll attempt to explain in a not too technical manner, but it is quite a bit to chew on all in one post. It would be worthwhile to educate yourself concerning dynamic range as applied to digital recording and as applied to analog vinyl recordings, the term "headroom", the term "loudness", the term "normalization", how the "replay gain" tag is supposed to function, how dBpa's "Replay Gain (apply) works, and the basics of dynamics processing. But really at this point, I'm somewhat flying blind as I'm not sure about the other features. ![]() I ran on test (Peak to Peak) but it did not boast it enough. I can do that for each album in VinylStudio and then re-run each of the following steps above, or I can do so in bulk using "Volume Normalize" in dBPoweramp (much more attactive). I have been advised to normaize the volume in the ripped copy to give it more punch. Abbey Road was a real clean copy and that is the one I'm using for this comparison. I've also experienced the same when comparing other LP to CD rips. The LP rip appears to be more muted while the CD has a crisper sound. I recently ripped a clean copy of Abbey Road from the LP as a hi-res rip ( MFSL version) and then compared it to an earlier CD rip.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |